Real bookings from our Front Range order log, from Broomfield to Castle Rock, written up step by step. We name the town, never the street or the customer. Same-day calls are usually reached in 30 to 60 minutes, booked visits start on time, and on every job the technician scans before drilling, keeps the dust contained and cleans up.
Four TVs, two consoles and a ceiling mount in Broomfield
A new-build family home where the parents wanted every screen done in a single Saturday. Two 65-inch sets went in the living room and basement, a 50-inch on a full-motion arm in the playroom, and a 50-inch on a ceiling mount in a loft with a sloped ceiling and no usable wall. The order also included soundbars under both 65s and wall brackets for a PS5 and a Nintendo Switch dock.
The visit was booked a week ahead for 8 a.m., and the technician arrived at 7:50 with every bracket loaded. The technician loaded every bracket at the warehouse that morning. On site, he started with the ceiling. He found the joists through the sloped drywall with the scanner, confirmed one with a pilot hole and bolted the plate into solid wood. He then cut the drop pole so the bottom of the screen clears the head of anyone walking under it.
The four in-wall runs went in next, each bay scanned for the new PEX lines these houses use. The console brackets were set at kid height beside the playroom TV, with the HDMI long enough to reach without strain. Everything was tested: both consoles, both soundbars on ARC, and the ceiling mount rotated to both seating areas. The new carpet got a drop cloth under every drilling spot.
A move across town with a Frame added at the new place
A couple leaving a Capitol Hill apartment for a house in Park Hill. The 65-inch and the 40-inch came down at the old place, the landlord-facing holes were patched so the deposit wasn't at risk, and both went back up in the house with the soundbar under the 65. A new 55-inch Frame went in the bedroom.
The technician met the couple at the old apartment 30 minutes after their call. The old building had plaster over brick on the outside wall. The technician pulled the anchors and filled each hole with patching compound, then smoothed it so it only needed a touch of paint. At the house, the walls were 1950s drywall over wood studs. He scanned each spot, avoiding a heating duct running up the living-room wall.
The Frame got its slim mount, leveled with a laser so it reads as a picture, and Art Mode was set up. Both moves were done in one afternoon.
A Frame over a tiled fireplace and a second 65" in Wheat Ridge
A brick ranch from the early '60s that the owners had remodeled, with new porcelain tile on the fireplace wall. They wanted a 65-inch Frame on the tile, looking like a painting over the mantel, and a regular 65-inch with a soundbar in the basement.
The technician reached Wheat Ridge 45 minutes after booking, with a diamond bit for the tile. Tile over a fireplace is where most DIY installs go wrong. The technician marked each hole with painter's tape, drilled with a diamond bit at low speed, then switched to a masonry bit for the brick behind. The vacuum nozzle stayed at the hole the whole time. The One Connect cable went down inside a framed section beside the firebox, which the scanner had confirmed was clear of the gas line.
In the basement, the fixed mount went into studs, the soundbar underneath, and the cable inside the wall. Both setups were tested. The tile was wiped clean, with no chips and no dust in the grout.
Swapping a 75" for a 98" with backlighting
The 75-inch came down to make room for a 98-inch. The owner also wanted a soundbar underneath, the cables inside the wall and an LED strip around the back for bias lighting.
Both technicians arrived at the start of the booked afternoon window. Two technicians came, because a 98-inch flexes if one person lifts it from the end. They laid the box flat, attached the arms of the bracket to the TV on a blanket on the floor, and lifted it together onto the wall plate. The plate had already been laser-leveled and lagged across three studs.
The LED strip was applied to the back edges before lifting. The in-wall run and the soundbar were finished, and everything was tested with the room lights off.
Five TVs, three swing arms and two soundbars in one Denver house
Five screens in a Washington Park foursquare. The 80-inch went in the living room on a full-motion arm so it can turn toward the dining area, with two 65s and two 55s in the bedrooms and the basement.
The technician arrived in Washington Park 40 minutes after the call. Old Denver houses have plaster and lath, which hides studs from cheap finders. The technician used a magnet to find the lath nails and confirmed every stud with a thin pilot bit before committing to bolt holes. The full-motion arms were lagged into two studs each and tested at full extension with a hand on the corner of the TV.
Both soundbars were mounted under the larger screens. Plaster dust was kept to a minimum with a vacuum attachment on the drill.
A 75" and an 86" in Castle Rock, one over the fireplace
A new Castle Rock build with a tall great-room wall. The 86-inch went over the gas fireplace, a 75-inch in the bonus room, and the customer's PS5 bracket went next to it.
Castle Rock was a booked slot at 1 p.m., and the two technicians were there at 12:55. The technician checked the heat above the fireplace and scanned the chase. Both cables went inside the walls. The 86-inch was lifted by two people. The PS5 bracket was mounted, and the console was tested.
Above the fireplace, the scanner confirmed the chase was framed with wood and the flue was set back, so the in-wall run went straight down to a plate by the media cabinet. The 75-inch in the bonus room got its own in-wall run past a horizontal fire block, drilled through with a flex bit.
The PS5 bracket went beside the 75-inch at shelf height. The console was connected and tested with a controller, and the drywall dust was vacuumed from both rooms.
Three TVs in Brighton, one on a swing arm
An 85-inch on a low fixed mount in the living room, a 65-inch on a full-motion arm in the kitchen nook, and a 55-inch in the bedroom.
The technician reached Brighton about 55 minutes after booking. Each wall was scanned. The kitchen arm was set so it folds flat against the wall. All three were leveled and tested.
Brighton new builds often have a sound-insulated wall between the garage and the living room. The scanner showed it, and the technician kept the 85-inch bracket on studs away from the garage side.
The 65-inch arm in the kitchen nook was set so the TV turns toward the dining table. All three were tested, and the dust was vacuumed.