Real bookings from our New Jersey order log, from Bergen County to the shore and South Jersey, described step by step. The town is real; streets and names are left out. Same-day calls are usually reached in 30 to 60 minutes, booked visits start inside the window, and every technician scans the wall before drilling, drills with a vacuum attached and cleans up before leaving.
Seven TVs and seven in-wall runs in Oakland
A colonial in Bergen County where the owners were wiring the whole house at once: a 65-inch in the family room, a 55-inch in the kitchen, three 50-inch sets in the bedrooms and two 40-inch screens in a home gym and an office. Every single one was to have its cables hidden inside the wall.
Seven TVs is a full day, so the visit was booked for 8 a.m., and the technician was in the driveway at 7:55 with seven in-wall kits. Seven in-wall runs in one house means seven chances to hit something. The technician scanned each stud bay for Romex, copper and PEX before cutting. In the kitchen he found a dishwasher supply line inside the planned bay and shifted the TV one bay over. The owner agreed after seeing it on the scanner screen.
He used an oscillating saw with a vacuum shroud for the openings, recessed plates top and bottom, and pulled HDMI and power through each wall. Second-floor rooms had a top plate to drill through, which was done with a long flex bit from the attic hatch. All seven TVs were leveled, powered on and tested, and the floors were vacuumed room by room before he left.
Four TVs and three soundbars in Audubon
A South Jersey twin home with three viewing spots, each with sound. The 75-inch went on a fixed mount in the living room, the 70-inch in the basement rec room and the 55-inch on a full-motion arm in the primary bedroom. A 40-inch went in the kitchen. All three soundbars came from our stock.
The technician reached Audubon 40 minutes after booking, with the three soundbar brackets from the warehouse. The basement wall turned out to be furring strips over block, so the technician skipped the strips and anchored the bracket into the concrete block with sleeve anchors, drilling with a hammer drill and the vacuum running. Upstairs, everything went into studs.
Each soundbar was centered under its TV with a gap so the screen can be adjusted without hitting it. HDMI ARC was tested on all three systems. The owner's cat stayed shut in a bedroom during drilling at the owner's request, and the dust was cleaned up before the door was opened.
An 86" and a 72" with hidden cables in Manchester Township
An 86-inch is past what one person can safely lift onto a bracket, so two technicians came. The 86-inch went in the great room with the customer's soundbar, and a 72-inch in the bedroom, both with in-wall wiring.
Both technicians arrived together at the start of the booked window. The great-room wall was 10 feet tall. The technicians used a laser line across the full width to set the bracket, then pulled power and HDMI through the wall to the outlet by the console. In the bedroom, the scanner showed a heating duct in the wall, so the cable went down the bay beside it.
The two of them lifted the 86-inch together and hooked it on in one move. The soundbar went on its included bracket, and both TVs were tested. Drywall dust was vacuumed off the carpet.
Two 75" swing arms with LED backlighting in Harrison
Two identical setups in a new townhouse near the PATH station: a 75-inch on a full-motion arm, the wires inside the wall and an LED strip behind each screen for bias lighting.
The technician got to Harrison 35 minutes after the call. The technician scanned each wall, lagged the arms into two studs each and fished the cables through. The LED strips were stuck to the back of each TV along the edges, with the USB power tucked behind. The arms were extended fully to make sure the strip cable didn't pull.
Both TVs were tested with the lights on and off, and the packaging was flattened for recycling.
A home office with two monitors and a TV in Watchung
Not every job is a living room. This customer wanted two 24-inch monitors on the wall above the desk, tilted to eye level, plus a 48-inch TV on the opposite wall for video calls.
This was booked for a Tuesday at 10, and the technician was there at 9:55. The technician measured the customer's seated eye height first and set the monitor tops just at it, to avoid neck strain. Both small tilting mounts went into one stud each with a toggle as a second point. The 48-inch went on a fixed mount bolted into two studs.
Monitors were connected and tested on the laptop dock. The desk was covered with a drop cloth during drilling.
A 90" and a 55" with two old TVs removed in Cherry Hill
Two old TVs came off, and a 90-inch and a 55-inch went up with in-wall wiring. A soundbar went under the 90-inch.
The two technicians arrived in Cherry Hill about 50 minutes after booking. The 90-inch bracket spans three studs. It was laser-leveled and lifted by two people. Both runs were scanned and cut cleanly, and the old bracket holes were left ready for spackle.
Moving one TV and hanging another in Lawrence Township
The 55-inch moved to a new spot in the same room, with a cord cover, and a 60-inch the customer already owned went on another wall.
The technician arrived 30 minutes after the call. Both new spots were scanned for studs and wiring, then leveled and tested. The empty wall was left with clean holes.
The 60-inch the customer already owned didn't have a bracket, so the technician brought a fixed mount from the van and matched it to the TV's VESA pattern. The 55-inch was reused on its existing bracket after he checked every bolt.
At the new spot, the scanner found a heating duct running up the wall. The bracket was shifted to the next stud pair, and the TV still ended up centered on the sofa.